Programming EEPROM from Linux

benmcollins · 02-11-2012, 03:40 PM

Hello,

The company I work for is engineering a system that makes use of the DisplayLink. It's non-x86, so can't boot windows. The DL-125 is on the PCB, so it can't be connected to anything else.

We have a 128k EEPROM attached to it. None of the open source drivers (libdlo, udlfb, etc) have EEPROM programming in it.

Also, I can't seem to find any generic firmware to load into it.

So, I would like to know if the manufacturing tools are available for Linux, and if so, where to get them.

02-11-2012, 03:40 PM	#1
benmcollins Junior Member Join Date: Feb 2012 Posts: 2	Programming EEPROM from Linux Hello, The company I work for is engineering a system that makes use of the DisplayLink. It's non-x86, so can't boot windows. The DL-125 is on the PCB, so it can't be connected to anything else. We have a 128k EEPROM attached to it. None of the open source drivers (libdlo, udlfb, etc) have EEPROM programming in it. Also, I can't seem to find any generic firmware to load into it. So, I would like to know if the manufacturing tools are available for Linux, and if so, where to get them.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode