|
|
Thread Tools | Search this Thread | Display Modes |
07-23-2013, 09:08 PM | #1 |
Junior Member
Join Date: Sep 2012
Posts: 16
|
Potential of frying DisplayLink USB 3.0 Docking Stations with Power over Ethernet?
Hello,
Would plugging a USB DisplayLink docking station into a live PoE (Power over Ethernet) network port potentially damage the docking station? I realize that by design PoE shouldn't provide power to non-PoE devices, but in my own personal experience I have seen some non-PoE devices get fried when plugged into PoE ports. The firm I work for has ordered well over a thousand Lenovo USB 3.0 docking stations (which utilize DisplayLink), and recently when a new office was setup the docking stations were all plugged into live PoE ports. Anywhere between 25-50% of those docking stations had problems, which is quite a bit more than usual when compared to our other locations that utilize the same docking stations with the same drivers, the same computer hardware, same OS, same standard software installed, the same peripherals, same DisplayLink drivers, etc. It should also be mentioned that all DisplayLink drivers have been installed exactly the way that the install guide says for the "corporate install". Typically we see somewhere between a 10%-20% failure rate of the docks where they have to be returned, so a 25%-50% failure rate seems unusually high, and the only difference that we can find at the moment is PoE vs non-PoE network ports. The specific issues we saw here were mostly video issues, such as:
The only way we were able to correct the issues were to power down the docking stations and turn them back on again. These issues would typically occur once every 5-20 minutes. Can you see any potential issues if you plug a DisplayLink USB docking station into a PoE network port? Has anybody had any issues when plugging a USB docking station into a live PoE port? Any assistance with this would be greatly appreciated. Thanks! |
07-24-2013, 08:37 AM | #2 |
Senior Member
Join Date: Feb 2009
Posts: 1,561
|
POE should not fry the dock. The Ethernet actually goes to a Realtek PHY interface before being passed to the DisplayLink chip anyway, so any POE would be filtered out by the PHY anyway.
I think any problem you are seeing would not be caused by POE. Wim |
07-24-2013, 02:29 PM | #3 |
Junior Member
Join Date: Sep 2012
Posts: 16
|
Thank you for the information!
So just curious, but what does the PHY interface do? |
Tags |
lenovo, poe, power over ethernet, usb docking station |
Thread Tools | Search this Thread |
Display Modes | |
|
|