|
|
Thread Tools | Search this Thread | Display Modes |
01-02-2021, 06:20 PM | #1 |
Junior Member
Join Date: Jan 2021
Posts: 1
|
Ubuntu 20.04 Boot Fail after DisplayLink Driver Installed ASUS TUF
I installed a fresh Ubuntu 20.04. The install went fine without a problem, the system had a boot issue which was resolved by adding nomodeset to grub. Then, I went to install the DisplayLink driver for my dock, following these instructions: https://support.displaylink.com/know...rticles/684649.
This seemed to work fine until I rebooted my laptop and was given an error message that shows: "sof-audio-pc1 000:00:1f.3: error: no reply expected, recieved 0x0" "HDMI HDA Codec ehdaud1o0D2:notifier register failed: err: -19" "HDMI HDA Codec ehdaud1o0D2:ASoC: failed to probe component -19" "sk1_hda_dsp_generic sk1_hda_dsp_generic: ASoC: failed to instantiate card -19" that error message was seen on booting. It won't go any further than that, I can switch tty and do a sudo displaylink-installer uninstall to remove the driver and the laptop works fine, but obviously unable to use the dock and therefore my other monitors. Can anyone help please? |
10-18-2021, 05:49 AM | #2 |
Junior Member
Join Date: Oct 2021
Posts: 2
|
What worked for me was removing nomodeset.
Context being - after removing nomodeset, I could get past the hdaudio hdaudio C0D3: unable to bind the codec error onto the login screen and could log in, but my HP laptop would shut down abruptly - which is why I had nomodeset in the first place. My NVIDIA drivers were messy. They wouldn't function, nor would they get installed properly. After some forum reading, it turned out that nomodeset isn't a necessity if nvidia drivers are installed properly. I installed a fresh copy of Ubuntu 20.04 LTS, booted in keeping nomodeset, apt installed nvidia-utils-470, rebooted. Now NVIDIA drivers don't boot with nomodeset. Rebooted into a root shell in recover mode, verified NVIDIA drivers are working with nvidia-smi. Removed nomodeset from grub, and rebooted. Everything was working fine now. Could install Display Link drivers and could reboot without any errors. |
11-04-2021, 09:53 PM | #3 |
Junior Member
Join Date: Nov 2021
Posts: 1
|
Same issue with dell Latitude and latest Ubuntu 20.04
I have installed the latest firmware of display link USB with version displaylink-driver-5.4.1-55.174.run and start or reboot of machine fails.
During boot there is no error and boot stop as following: [ OK ] Started Snap Daemon. Starting Wait until snapd is fully seeded„. [ OK ] Started Daemon for power management. [ OK ] Finished Wait until snapd is fully seeded, Starting Load/Save Screen Backlight Brightness of becklight:intel_backlight... [ OK ] Finished Load/Save Screen Backlight Brightness of becklight:intel_backlight. Starting Save/Restore Sound Card State... [ OK ] Finished Save/Restore Sound Card State. [ OK ] Reached target Sound Card. [ OK ] Finished Network Manager Wait Online. [ OK ] Reached target Network is Online. Starting Docker Application Container Engine... [ OK ] Starting Tool to automatically collect and submit kernel crash signatures... [ OK ] Started crash report submission daemon. [ OK ] Started Tool to automatically collect and submit kernel crash signatures. _ If i remove driver with: sudo displaylink-installer uninstall Ubuntu start correctly. I'm not able to open a ticket because there is no error. Do you have some idea to see where could be a log to see the problem? Thnaks Last edited by gigiofreestyle; 11-04-2021 at 09:56 PM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|