DisplayLink Forum - View Single Post - Displaylink 2nd and 3rd monitor setup--[solved] Is only working for 2 monitors.

crock · 05-19-2020, 08:04 PM

I've been in IT for 20 odd years so I like to think I know what I'm doing.

I bought a D6000 as a test for a possible rollout in our office. I've connected 8 laptops to it, every single one powered 2 monitors beautifully and if they charge over USB-c they charged!
Except of course my laptop, it would only kick one external monitor up. I've spent ages trawling this forum, messing around trying to clean out some old Fresco drivers that turned out to be irrelevant, uninstalled, re-installed drivers, bios update just in case, changed cables. I did everything I could think of then spotted this post.

I hadn't even thought about just removing the 'bad' display, the second I did it kicked it up like a good un'

I'd like to thank you for taking the 2 minutes to post this thread, hopefully someone else will find it useful too!

05-19-2020, 08:04 PM	#2
crock Junior Member Join Date: May 2020 Posts: 1	Thank you! I've been in IT for 20 odd years so I like to think I know what I'm doing. I bought a D6000 as a test for a possible rollout in our office. I've connected 8 laptops to it, every single one powered 2 monitors beautifully and if they charge over USB-c they charged! Except of course my laptop, it would only kick one external monitor up. I've spent ages trawling this forum, messing around trying to clean out some old Fresco drivers that turned out to be irrelevant, uninstalled, re-installed drivers, bios update just in case, changed cables. I did everything I could think of then spotted this post. I hadn't even thought about just removing the 'bad' display, the second I did it kicked it up like a good un' I'd like to thank you for taking the 2 minutes to post this thread, hopefully someone else will find it useful too!