I reinstalled with Legacy BIOS to see if UEFI did anything... same errors.
Of note, the detection of the device as "usb-storage" or "uas" - this seems to be the fundamental problem. From DMESG.
Code:
[ 3.223077] usb 1-4.7.2.2: New USB device found, idVendor=17e9, idProduct=0199
[ 3.223081] usb 1-4.7.2.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 3.223082] usb 1-4.7.2.2: Product: Mini USB Monitor
[ 3.223084] usb 1-4.7.2.2: Manufacturer: DisplayLink
[ 3.223085] usb 1-4.7.2.2: SerialNumber: 100144
[ 3.243460] usb-storage 1-4.7.2.2:2.0: USB Mass Storage device detected
[ 3.243773] scsi host2: usb-storage 1-4.7.2.2:2.0
[ 3.244106] usbcore: registered new interface driver usb-storage
[ 3.245774] usbcore: registered new interface driver uas
[ 3.309859] usb 1-4.7.2.4: new full-speed USB device number 10 using xhci_hcd
[ 3.415940] usb 1-4.7.2.4: New USB device found, idVendor=0eef, idProduct=0001
[ 3.415945] usb 1-4.7.2.4: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 3.415948] usb 1-4.7.2.4: Product: USB TouchController
[ 3.415950] usb 1-4.7.2.4: Manufacturer: eGalax Inc.
[ 3.418955] input: eGalax Inc. USB TouchController as /devices/pci0000:00/0000:00:15.0/usb1/1-4/1-4.7/1-4.7.2/1-4.7.2.4/1-4.7.2.4:1.0/0003:0EEF:0001.0004/input/input19
[ 3.419332] input: eGalax Inc. USB TouchController as /devices/pci0000:00/0000:00:15.0/usb1/1-4/1-4.7/1-4.7.2/1-4.7.2.4/1-4.7.2.4:1.0/0003:0EEF:0001.0004/input/input20
[ 3.419583] hid-generic 0003:0EEF:0001.0004: input,hidraw3: USB HID v2.10 Pointer [eGalax Inc. USB TouchController] on usb-0000:00:15.0-4.7.2.4/input0
[ 3.432054] usbcore: registered new interface driver usbtouchscreen
[ 3.578719] evdi: loading out-of-tree module taints kernel.
[ 3.580727] evdi: [I] Initialising logging on level 5
[ 3.580729] evdi: [I] Atomic driver:no
[ 3.650168] usb 1-4.7.2.2: usbfs: interface 0 claimed by usb-storage while 'DeviceManager_0' sets config #1
[ 3.902464] [drm] RC6 on
[ 4.254469] scsi host2: scsi scan: INQUIRY result too short (5), using 36
[ 4.254475] scsi 2:0:0:0: CD-ROM PQ: 0 ANSI: 0
[ 4.254991] scsi 2:0:0:0: Attached scsi generic sg1 type 5
[ 4.263376] sr 2:0:0:0: [sr0] scsi3-mmc drive: 8x/40x writer xa/form2 cdda tray
[ 4.263379] cdrom: Uniform CD-ROM driver Revision: 3.20
[ 4.263784] sr 2:0:0:0: Attached scsi CD-ROM sr0
[ 4.281204] xhci_hcd 0000:00:15.0: WARN Event TRB for slot 8 ep 8 with no TDs queued?
[ 4.644348] usb 1-4.7.2.2: usbfs: interface 0 claimed by usb-storage while 'DeviceManager_0' sets config #1
[ 5.649379] usb 1-4.7.2.2: usbfs: interface 0 claimed by usb-storage while 'DeviceManager_0' sets config #1
[ 6.654684] usb 1-4.7.2.2: usbfs: interface 0 claimed by usb-storage while 'DeviceManager_0' sets config #1
[ 7.661063] usb 1-4.7.2.2: usbfs: interface 0 claimed by usb-storage while 'DeviceManager_0' sets config #1
And if you review "lsusb -v -d 17e9:" you can see some unrecognized data:
Code:
Bus 001 Device 009: ID 17e9:0199 DisplayLink
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x17e9 DisplayLink
idProduct 0x0199
bcdDevice 1.36
iManufacturer 1 DisplayLink
iProduct 2 Mini USB Monitor
iSerial 3 100144
bNumConfigurations 2
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 2
iConfiguration 1 DisplayLink
bmAttributes 0xc0
Self Powered
MaxPower 500mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 8 Mass Storage
bInterfaceSubClass 6 SCSI
bInterfaceProtocol 80 Bulk-Only
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x03 EP 3 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x84 EP 4 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 0
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 66
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0x80
(Bus Powered)
MaxPower 500mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 3
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 0
bInterfaceProtocol 0
iInterface 0
** UNRECOGNIZED: 1b 5f 01 00 19 05 00 01 03 00 04 04 01 00 03 d0 00 02 04 00 bd 1f 00 01 04 01 02
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x82 EP 2 IN
bmAttributes 3
Transfer Type Interrupt
Synch Type None
Usage Type Data
wMaxPacketSize 0x0008 1x 8 bytes
bInterval 4
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x0a EP 10 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 0
Device Qualifier (for other device speed):
bLength 10
bDescriptorType 6
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
bNumConfigurations 2
Device Status: 0x0000
(Bus Powered)
Any Thoughts?