DisplayLink Forum - View Single Post

steuk · 11-06-2009, 11:16 PM

Greetings. It seems I started yodeling too early - it doesn't work as I wish.
Exactly: After started in "win2k-mode", the driver has been installed and a 2nd monitor is listed in the display properties. Nevertheless, device manager lists a monitor named "none" (uh, there is a no-device plugged in. greetings from nietzsche!) and resolution of this none-monitor has only default values of eg. 640x480; correct resolution is not listed.

This all wouldn't matter.
BUT, ladies and gentlemen, the worst thing with this: The f....g device doesn't display anything!

Allright, so I don't have a sollution, too. But maybe this could be an approach for someone of you. I'd be lucky to hear about!

11-06-2009, 11:16 PM	#17
steuk Junior Member Join Date: Nov 2009 Posts: 2	not quite yet :-/ Greetings. It seems I started yodeling too early - it doesn't work as I wish. Exactly: After started in "win2k-mode", the driver has been installed and a 2nd monitor is listed in the display properties. Nevertheless, device manager lists a monitor named "none" (uh, there is a no-device plugged in. greetings from nietzsche!) and resolution of this none-monitor has only default values of eg. 640x480; correct resolution is not listed. This all wouldn't matter. BUT, ladies and gentlemen, the worst thing with this: The f....g device doesn't display anything! Allright, so I don't have a sollution, too. But maybe this could be an approach for someone of you. I'd be lucky to hear about!