Monitor doesn't receive signal

[tstephens]

Hi,

I just tried to setup my displaylink adapter. Windows is showing the 3rd monitor, but the screen isn't detecting any signal. I've tried plugging the screen into one of the regular display ports, and it works. So I know the screen isn't the issue itself. I also tried using a different monitor with the adapter (one that also works on a normal port) and was unsuccessful.

I'm running Win7 x64 - Nvidia NVS 4200 - the screen is a Dell U2410.
I've tried multiple usb ports and now I have it plugged into a powered usb hub to make sure power wasn't an issue.

I walked through all the steps on the troubleshooting page and everything looks good. Like I said, windows recognizes the screen, the display just doesn't seem to be receiving any information.

Any help would be appreciated!
Thanks
-Tom

EDIT: adding attached support info

[Wim]

Hi

Thanks for the logs. All looks ok, although you are in basic graphics mode - I'd recommend you switch to Aero, but I don't think this is the cause of the issue you are seeing.

If you drag a window over to the display, does the LED on the adapter flicker? If it does then this shows that the software is sending video data and the chip in the adapter is receiving it.

If you change resolution, does the adapter start working?

Wim

[tstephens]

Thanks for looking things over.

I've tried every resolution I'm getting as an option and nothing. Dragging a window to the display hasn't made a difference either.

For the sake of experimentation I turned on Aero (I usually leave it off for performance reasons probably doesn't matter much on this pc but still...). Anyway, that didn't make a difference either.

Thanks
- Tom

[Dan]

Have you tried the USB device on a different system? You could also try using an analog connection instead of digital. Everything so far I'm afraid is indicating a rare hardware failure with the unit. The first hint that something is working should be that the monitor goes out of standby (usually indicated by an amber light), you should also get the main screen blinking as Windows rearranges the outpouts.

It's just possible that there is no digitial output coming, out of the unit, but there may be an analog one (hence the suggestion).

[tstephens]

Hi, great it does work. So the problem seems to be related to the digital signal.

So I need to get a replacement adapter, correct?

[Wim]

Yes - it does seem that the digital output is not working (so a hardware fault), if analogue works correctly.

Wim

[stormat]

Same thing is happening to me. I have 3 TVs connected to a main PC. While the TVs display the images, if I turn off any TV for an extended period of time then turn it back on, it will not re-acquire the signal. I have tested with 4 different UGAs to no avail. If I turn the TV off briefly then back on again it does work.