|
11-06-2018, 08:24 PM | #1 |
Junior Member
Join Date: Nov 2018
Posts: 1
|
Same issue here
I am using Ubuntu 18.04 on Dell XPS 15 (9550) laptop. I updated the firmware for both the Dell laptop and the Dell DisplayLink D6000
I have two Dell U2415 monitors connected to the display ports. The DisplayLink randomly disconnects and I see the following log messages: [100477.245855] usb 4-1.1: Disable of device-initiated U1 failed. [100477.252819] usb 4-1.1: Disable of device-initiated U2 failed. [100477.252892] cdc_ncm 4-1.1:1.5 enx9cebe88af7b4: unregister 'cdc_ncm' usb-0000:3e:00.0-1.1, CDC NCM [100477.292858] usb 4-1.1: Set SEL for device-initiated U1 failed. [100477.299828] usb 4-1.1: Set SEL for device-initiated U2 failed. [100477.457709] userif-4: sent link down event. [100477.457711] userif-4: sent link up event. [100477.626135] usb 4-1.1: reset SuperSpeed USB device number 3 using xhci_hcd [100477.663572] usb 4-1.1: Warning! Unlikely big volume range (=767), cval->res is probably wrong. [100477.663575] usb 4-1.1: [4] FU [Mic Capture Volume] ch = 2, val = -4592/7680/16 [100477.664076] usb 4-1.1: Warning! Unlikely big volume range (=672), cval->res is probably wrong. [100477.664078] usb 4-1.1: [7] FU [Dell USB Audio Playback Volume] ch = 6, val = -10752/0/16 [100477.686576] cdc_ncm 4-1.1:1.5: MAC-Address: 9c:eb:e8:8a:f7:b4 [100477.686578] cdc_ncm 4-1.1:1.5: setting rx_max = 16384 [100477.686638] cdc_ncm 4-1.1:1.5: setting tx_max = 16384 [100477.686847] cdc_ncm 4-1.1:1.5 usb0: register 'cdc_ncm' at usb-0000:3e:00.0-1.1, CDC NCM, 9c:eb:e8:8a:f7:b4 [100477.687672] usb 4-1.1: usbfs: process 22580 (DeviceWindowDis) did not claim interface 0 before use [100477.689538] cdc_ncm 4-1.1:1.5 enx9cebe88af7b4: renamed from usb0 [100477.715153] IPv6: ADDRCONF(NETDEV_UP): enx9cebe88af7b4: link is not ready [100477.715262] IPv6: ADDRCONF(NETDEV_UP): enx9cebe88af7b4: link is not ready [100477.733959] cdc_ncm 4-1.1:1.5 enx9cebe88af7b4: network connection: disconnected [100482.582012] cdc_ncm 4-1.1:1.5 enx9cebe88af7b4: 1000 mbit/s downlink 1000 mbit/s uplink [100482.614013] cdc_ncm 4-1.1:1.5 enx9cebe88af7b4: network connection: connected [100482.614097] IPv6: ADDRCONF(NETDEV_CHANGE): enx9cebe88af7b4: link becomes ready [100482.814536] userif-4: sent link down event. [100482.814538] userif-4: sent link up event. [100486.994095] userif-4: sent link down event. [100486.994098] userif-4: sent link up event. [100488.134488] userif-4: sent link down event. [100488.134493] userif-4: sent link up event. Last edited by mstoilov; 11-07-2018 at 02:46 AM. |
Tags |
17.10, brainstorm, linux |
|
|