DisplayLink Forum - View Single Post

Joachim Martillo · 10-20-2017, 04:40 PM

Should they work together?

I am using a D1000 docking station attached to a Dell XPS-13-9350.

lsusb -d 17e9:

produces

Bus 002 Device 006: ID 17e9:436c Displaylink

This setup worked with the previous driver and 17.04.

If I disconnect and reconnect the USB3 cable to the docking station, my display flashes as if there is an attempt to detect displays (both the builtin display and the Hanstar display attached to the docking station), but in displays configuration, the attached Hanstar display does not appear.

Maybe I should have stuck with the previous setup, but the audio subsystem was terribly broken, and I needed it for some development work.

Any suggestions for troubleshooting?

The Ubuntu troubleshooting webpage below seems out of date.

http://support.displaylink.com/knowl...work-on-ubuntu

10-20-2017, 04:40 PM	#4
Joachim Martillo Junior Member Join Date: May 2016 Posts: 21	Ubuntu 17.10: driver 1.4.210 kernel 4.13.0-16.generic Should they work together? I am using a D1000 docking station attached to a Dell XPS-13-9350. lsusb -d 17e9: produces Bus 002 Device 006: ID 17e9:436c Displaylink This setup worked with the previous driver and 17.04. If I disconnect and reconnect the USB3 cable to the docking station, my display flashes as if there is an attempt to detect displays (both the builtin display and the Hanstar display attached to the docking station), but in displays configuration, the attached Hanstar display does not appear. Maybe I should have stuck with the previous setup, but the audio subsystem was terribly broken, and I needed it for some development work. Any suggestions for troubleshooting? The Ubuntu troubleshooting webpage below seems out of date. http://support.displaylink.com/knowl...work-on-ubuntu Last edited by Joachim Martillo; 10-20-2017 at 04:45 PM.